Can-Am Offroad Cobra Cooler Belt Cooling System by Assault Industries
The Assault Industries Cobra Cooler is a coolant injection system that works to reduce clutch housing temperatures by as much as 50ºF. Keeping temperatures down can dramatically reduce the risk of belt failures.
At the flip of a momentary switch, the system injects distilled water into the clutch housing air intake tube as a fine mist intermittently over the course of 90 seconds. Temperatures will immediately begin to drop until the system shuts off.
Temperatures will climb back up over the next several minutes. Operation is recommended when housing temperatures reach 195ºF which is approaching critical.
Since clutch components are aluminum, corrosion is not a factor. The Cobra Cooler will not flood the housing or cause belt skipping as it is not enough moisture. The housing temperatures will also cause a certain amount of evaporation, so while the vehicle is in use, there should be little to no standing water inside the housing. This system is designed to save your belt, clutches and housing from being destroyed by an imploding belt. Clutch/belt housing and its internal components should still be routinely maintained along with everything else on the vehicle for maximum performance and longevity.
Features :
- Works on belt driven drivetrains
- Reduces temps by up to 50ºF
- Over 2000mi in race conditions with no belt failures
- Ready to install
- Long lasting 4qt bottle with integrated water pump
- Uses distilled water
- Does not damage housing components
- Patent Pending
- Made in the USA
- Temperature gauge not included.
Featured Blog Post: Overcome overheating issues with these Can-Am Maverick engine cooling tips, tricks, and pieces of advice.
